Yamaha YFM700RSE Owner's Manual page 119

3
1. Adjusting bolt
2. Cable length "A"
3. Locknut
1. Release the parking brake by moving the
parking brake lever to the right.
2. Fully loosen the locknut and the adjusting bolt
at the rear brake caliper.
3. Slide the rubber cover back at the brake ca-
ble.
4. Loosen the locknut.
5. Turn the parking brake free play adjusting nut
in direction (a) to increase the cable length,
and in direction (b) to decrease it.
2
1
(b)
1
(a)
1. Rubber cover
2. Parking brake free play adjusting nut
3. Locknut
TIP
If the cable length cannot be adjusted to specifi-
cation, consult a Yamaha dealer.
6. Tighten the locknut on the brake cable.
7. Slide the rubber cover to its original position.
8. Turn in the adjusting bolt at the rear brake cal-
iper until it feels tight, then turn it out 1/8 turn
and tighten its locknut to the specified torque.
NOTICE: When tightening the locknut,
8-35
2
3
8