Specifications; Attachments/Accessories - Toro 30692 Operator's Manual

Blade Control Lever (PTO)
This lever is used in conjunction with the blade control
bail to engage and disengage the mower deck belt and
drive the mower blades.
Gear Shift Lever
The transmission has five forward speeds, neutral and
reverse, and has an in-line shift pattern.
Important: Do not shift while unit is moving, as
transmission damage may occur.
Upper Control Bar
Shift to the desired gear and push forward on the upper
control bar and blade control bail to engage forward
traction operation and pull back to brake forward
movement. Pull back on right side of upper control bar
to turn right and left side to turn left.
Lower Control Bar
Shift transmission to reverse and squeeze the lower
control bar and handle together to engage the rearward
traction assist.
Parking Brake Lever
Pull back on upper control bar and swing brake lever
up against the upper handle to set the parking brake
(Figure 4).
Ignition Switch
This switch is used in conjunction with recoil starter and
has two positions: Run and Off.
Recoil Starter
Pull recoil starter handle to start engine (not shown in
Figure 4).
Fuel Shut-off Valve
Close the fuel shut-off valve when transporting or
storing mower.
Choke
Use the choke to start a cold engine.

Specifications

Note: Specifications and design are subject to change
without notice.
32 inch mowers:
Width with deflector down
Length
Height
Weight
36 inch mowers:
Width with deflector down
Length
Height
Weight

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
10
45.8 inches (116.3 cm)
72 inches (183 cm)
41 inches (104.1 cm)
400 lb (181 kg)
46.6 inches (118.4 cm)
74 inches (188 cm)
41 inches (104.1 cm)
460 lb (209 kg)