Specifications - Toro 39488 Operator's Manual

1. Safety interlock symbols
2. Battery light
Throttle Control
The throttle control has two positions: Fast and Slow.
Choke
Use the choke to start a cold engine.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage
the electric clutch to drive the mower blades with the
right side motion control lever in the center, un-locked
position. Pull the switch up to engage the blades and
release. To disengage the blades, push the blade control
switch (PTO) down or move or release the right side
motion control lever into the neutral lock position.
Ignition Switch
This switch is used to start the mower engine and has
three positions: Start, Run and Off.
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system to engage and disengage the mower blades and
to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (under the fuel tank ) when
transporting or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
Figure 6
3. Hour meter
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.

Specifications

Note: Specifications and design are subject to change
without notice.
36 inch mowers:
Width with deflector down
Length
Height
Weight
48 inch mowers:
Width with deflector down
Length
Height
Weight
12
51–1/8 inches (130 cm)
78–1/2 inches (199 cm)
46 inches (117 cm)
667 lb (303 kg)
63–1/2 inches (161 cm)
77–3/4 inches (198 cm)
46 inches (117 cm)
682 lb (309 kg)