Figure 16
1. Upper handle
2. Rear frame
3. Flange bolt (3/8 x 1 inch)
3. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 16).
4. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and flange
nuts into mounting holes. Tighten all flange bolts.
5. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter.
6. Check the parking brake adjustment. Refer to
Checking the Brakes in , page .
4. Lock nut (3/8 inch)
5. Upper mounting hole
6. Lower mounting hole
18