6
Charging the Battery
No Parts Required
Procedure
Charging the battery produces gasses that can
explode and cause serious injury.
• Keep cigarettes, sparks and flames away
from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the battery
in an enclosed space.
Important: Do not run the machine with the
battery disconnected; electrical damage may occur
to the engine.
Charge the battery. Refer to the Operator's Manual for
instructions.
Figure 11
7
Checking the Machine for
Grease
Parts needed for this procedure:
Number 2 general purpose lithium base or
1 tube
molybdenum base grease. (Purchase separately.)
Procedure
1. Remove the belt covers as shown below.
1. Belt cover
2. Check the tensioning arm for grease.
3. Check the grease for the three spindle bearings. If
needed, add grease until it comes out of the lower
seals.
4. Install the belt covers.
5
Figure 12
2. Latch