Toro 74922 Operator's Manual page 57

1
Figure 88
1. Deck lift pedal
2. Height of cut pin
6. Insert the height adjustment pin into the 3 inch (7.6
cm) cutting height location.
7. Release the transport lock and allow the deck to lower
to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the level
surface to the front tip of the blade (Postion A).
The measurement should read 3 inches (7.6 mm)
(Figure 89).
Figure 89
1. 3 inches (7.6 cm) at A is
correct
2. 3 1/4 inches (8.3 cm) at B
is correct
3
G017027
3. Transport lock
3. Measure here from the
blade tip to hard surface
4. Measure at A and B on
both sides
10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it (Figure 90).
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
2
2
1
G012430
1. Adjustment nut
2. Jam Nut
11. If the front deck links do not have enough adjustment
to achieve accurate cut height , the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the two bolts
at the bottom of the height of cut plate. Refer to
Figure 91.
57
3 4
2 1
Figure 90
3. Rear deck adjustment
4. Front deck adjustment