Table of Contents
Advertisement
1. Rear axle boot (each side)
EBU24752
Brake light switches
The operation of the brake light switches must be
8
checked and, if necessary, adjusted at the inter-
vals specified in the periodic maintenance and lu-
brication chart.
The brake light switch for the brake pedal can be
adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
1. Remove panel A. (See page 8-9.)
TIP
The brake light switch is properly adjusted when
the brake light comes on just before braking takes
effect.
2. Turn the brake light switch adjusting nut while
holding the brake light switch in place. To
make the brake light come on earlier, turn the
adjusting nut in direction (a). To make the
brake light come on later, turn the adjusting
nut in direction (b).
1. Brake light switch
2. Brake light switch adjusting nut
3. Install the panel.
8-37
Advertisement
Table of Contents
Troubleshooting
