Preparation (2)-② - KUKEN PTS-800 EX Operation Manual

Preparation (2)-②
This section describes how to select and set each mode.
Please follow the instruction below.
① Make sure the machine is turned off.
Press ③ for a few second and press the power
switch while pressing ③.
To select Transmission Mode
② Press ① key once to change the mode from the [Prn].
And press ① again to change the mode back to [PC]
If the PTS is non-transmission model, either can be selected.
③ Press ② to complete the selection.
Then the selection will move to the next setting.
To select Loosening Mode
④ Press ① key once to change the mode from the [Aut].
And press ① again to change the mode back to [Ind].
⑤ Press ② to complete the selection.
Then the selection will move to the next setting.
To select [ CH1 ] Mode
⑥ Press ① key once to change the mode from the [CH1] on.
And press ① again to change the mode back to [CH-] off.
⑦ Press ② to complete the selection.
After the selection of [CH1], the power will be turned off.
Initial Setting ( Operation )
keep on pressing
Press to turn on