Toro Z master G3 Operator's Manual page 35

1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 46).
1
3
6
8
Figure 46
2
4 5
7
10
9
G008792
Changing the Engine Oil
Service Interval: After the first 8 hours
Note: Dispose of the used oil at a recycling center.
1. Start the engine and let it run five minutes. This
warms the oil so it drains better.
2. Park the machine so that the rear is slightly lower
than the front to ensure the oil drains completely.
3. Disengage the PTO, move the motion control levers
G008804 to the neutral locked position and set the parking
brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 47).
1
3
4
35
Every 100 hours (more often in dirty
or dusty conditions)
2
4
5
Figure 47
G008804
G008793