Operation; Checking The Engine Oil Level - Toro 22176 Operator's Manual

21in heavy-duty recycler/rear bagger
Hide thumbs Also See for 22176:
Table of Contents

Advertisement

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
Each time before you mow, make sure that the
self-propel drive and the blade control bar operate
properly. When you release the blade control bar,
the blade and self-propel drive should stop. If they
do not, contact an Authorized Service Dealer.
This machine produces sound levels in
excess of 85dBA at the operator's ear and
can cause hearing loss through extended
periods of exposure.
Wear hearing protection when operating
this machine.
Figure 11
1. Warning—wear hearing protection.
Checking the Engine Oil
Level
Initially, fill the crankcase with 30 ounces (0.88
liters) of oil. Use only high-quality SAE 30 or SAE
10W30 weight detergent oil that has the American
Petroleum Institute (API) service classification SF,
SG, SH, or SJ.
Oil Capacity
With oil lter
Without oil lter
Before each use, ensure that the oil level is between
the Add and Full marks on the dipstick (Figure 12).
30 ounces (0.88 L)
24 ounces (0.70 L)
Figure 12
1. Dipstick
2. Full
Note: When the crankcase is empty, pour
about 3/4 of the crankcase capacity of oil in
the crankcase, then follow the procedure in this
section.
1. Move the lawn mower to a level surface.
2. Clean around the dipstick (Figure 12).
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the filler neck, then
remove it.
Note: To ensure an accurate oil level reading,
you must fully install the dipstick.
6. Read the oil level on the dipstick (Figure 12).
7. If the oil level reading is below the Add mark
on the dipstick, slowly pour only enough oil
into the filler hole to raise the oil level to the
Full mark on the dipstick.
Important: Do not overfill the crankcase
with oil and run the engine; engine damage
will result. Drain the excess oil until the oil
level on the dipstick reads Full.
8. Insert the dipstick into the filler neck and
rotate the cap clockwise until it is tight.
12
3. Add

Advertisement

Table of Contents
loading

This manual is also suitable for:

2217s

Table of Contents