Table of Contents
Advertisement
ForcePad (Touchpad)
Description
ForcePad
Cable Kit
Before removing the ForcePad, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the ForcePad:
1.
Disconnect the ForcePad cable (1) from the system board.
2.
Disconnect the NFC module antenna cable (2) from the ForcePad.
3.
Remove the six Phillips PM2.0×2.0 broadhead screws (3) that secure the ForcePad to the computer, and
then lift the ForcePad from the computer (4).
Reverse the removal procedures to install the ForcePad.
Bottom cover on page
Battery on page
43).
24).
Component replacement procedures
Spare part number
842287-001
842293-001
47
Advertisement
Table of Contents
