Printer Buttons And Lights - Primera LX2000 Operator's Manual

7. Install the Setup Cartridges that came with your new Print Head. These cartridges are
partially filled and specially coded. The Print Head will not function until these
cartridges are installed.
8. Close the cover. The priming process of the Setup Cartridges will begin. After the
priming procedure is complete, you may use these setup cartridges until they are
empty.
9. You will be prompted to run an alignment print once the Print Head has been primed.
See Section 3E for more information.
H. Printer Buttons and Lights
Button/Cover Functions:
RESUME/FEED-BUTTON:
Printer State
SYSTEM IDLE:
SYSTEM PAUSED:
SYSTEM BUSY PRINTING
ERRORS PRESENT:
PAUSE/UNLOAD-BUTTON:
Printer State
SYSTEM BUSY PRINTING:
COVER OPEN:
SYSTEM PAUSED:
CANCEL-BUTTON:
COVER OPEN SENSOR:
WHEN COVER OPENED:
COVER CLOSED:
BUTTON COMBINATIONS
LOAD-BUTTON and
UNLOAD-BUTTON
LOAD-BUTTON and
CANCEL-BUTTON
Press Action
Feeds to next label, Cuts the label if cutter enabled.
Cuts current label in LOAD BUTTON CUT MODE.
Unpauses system.
Pauses system.
Retries to correct error or just clears error state
Press Action
Pauses system.
Unloads stock.
Unpauses system/Resumes Printing.
Cancels current job in progress.
Pauses current job if active, will finish printing current label.
Moves Carrier to Head Change Position.
If closed after it has been opened the Printer will be in
pause mode. Press Resume/Feed to continue.
Hold buttons down until Wireless symbol changes; this
will toggle the wireless antennae ON/OFF.
After 2 seconds will reset the Printer
Install the Setup
Cartridges in the New
Print Head.
Troubleshooting and Maintenance 43