Documents That Can Be Loaded Directly Into The Scansnap - Fujitsu ScanSnap s1100i Basic Operation Manual

Documents That Can Be Loaded Directly into the ScanSnap

Conditions for documents that can be loaded directly into the ScanSnap are as follows:
Eject method With the output guide closed
(*1)
Document type Office paper, postcards, business cards
Plastic cards conforming to the ISO7810 ID-1
type (54 × 86 mm/3.37 × 2.13 in.) (*2)
Paper weight
52.3 to 209.3 g/m
When merging scanned images
automatically (*3)
52.3 to 104.7 g/m
Plastic cards
0.76 mm (0.03 in.) or less (embossed cards
can be used)
Paper size Width
25.4 to 216 mm (1 to 8.5 in.)
For a dual scan, a total width of 200 mm (7.87 in.) or less for two documents
Length
25.4 to 863 mm (1 to 34 in.)
When merging scanned images automatically (*3)
l A3 (297 × 420 mm)
l B4 (257 × 364 mm)
l Double Letter (11 × 17 in. (279.4 × 432 mm))
*1: For details about the eject methods, refer to
*2: A dual scan cannot be used for plastic cards.
*3: Fold in half to scan.
ATTENTION
l The following types of documents must not be scanned:
- Documents attached with the metals such as paper clips or staples that can damage the inside
of the ScanSnap
Remove the metals for scanning.
- Documents on which the ink is still wet
Wait until the ink dries completely to scan these documents.
- Documents larger than 216 × 863 (mm)/8.5 × 34 (in.) (width × length)
- Documents other than paper such as fabric, metal foil and OHP film
l When you scan picture postcards, be aware that the picture side may get damaged. It is the
responsibility of the customer to scan picture postcards.
l Be careful of the following when you scan plastic cards:
- Cards that are bent may not be fed properly.
- If the surface of the card is dirty with grease marks such as fingerprints, perform scanning after
wiping the dirt off.
2
(14 to 56.1 lb)
2
(14 to 28 lb)
"Parts and Functions" (page
51
With the output guide open
Office paper
2
52.3 to 80 g/m (14 to 20 lb)
35).
Documents to Scan