Page 1
Address RS-106R-P USER'S MANUAL Introduction of RS-106R-P What is reverse osmosis Components & Selected filters Cartridge filters The parts of RS-106R-P Tubing connection diagram Installation diagram Change filters Change membrane Operation regulation The functions of Infra-Red filter Maintenance checking list Memo Thank you very much for selecting Pure-Pro Water Corp.
Page 2
RO water production. This allows for better assurance that there is adequate water available when desired, even during heavy use times of the day. PurePro ROYAL RO with its supreme quality ensures a great water flow rate with absolutely the least wasting of water.
Page 3
Water flow Q: What does the PurePro series drinking water taste like? The taste of the PurePro water depends on the amount of contaminants in the tap water originally. If 95% of dissolved minerals and chemicals are removed, the R.O. water may taste like distilled water (no minerals), bottled water (low mineral), or natural spring water (moderate mineral content).
Page 4
Components & Selected filters The functions of Infra-Red filter ¨Components Far Infrared rays (FIR) are part of the sunlight spectrum, which is invisible to the naked eye. The wavelength of the far infrared rays ranges from 4 microns to 1000 microns. The recent studies in biotechnology field revealed that the far-infrared rays played an important role for formation and growth of all living organisms.
Page 5
Operation regulation Cartridge filters A.With everything connected, turn on the water check for leaks. Cartridge Filters Filter Description Service Life B.Make sure the storage tank shut-off valve is "OFF". Open the sink Stage 1 RS300ST 6 Months top faucet. With only five micron rating. It is effective in 5 Micron C.Within a few minutes (up to 15) the water will start to run from the removing dirt, rust and sand particles.
Page 6
The parts of RS-106R-P Operation regulation Plug in electricity. Turn on water source. Pump To RO system Pressure gauge The 3rd stage filter The 1st stage filter Switch on water tank. Let the water run for at least 30 minutes. This flushes the carbon filters on first time use.
Page 7
Change membrane Tubing connection diagram CONNECTING THE COLOR TUBING: Unplug electricity. Turn off water source. Switch off water tank. A. Connect the WHITE tubing to the water supply connector. To RO system B. Connect the BLUE tubing to the sink top faucet. C.
Page 8
Installation diagram Change filters Input water : Install water tank : Turn off water source. Unplug electricity. Tank ball shut- off valve Water supply connector To RO system To RO system Hand tighten To RO system plastic shut-off valve to tank. Then connect color tubing.
Need help?
Do you have a question about the RS-106R-P and is the answer not in the manual?
Questions and answers