Panasonic CF-19 Series Operating Instructions Manual page 8

Regulatory Information
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC RF Exposure Warning:
 This equipment is provided with PC Card slot that could be
used with wireless transmitters, which will be specifi cally
recommended when they become available.
Other third-party wireless transmitters have not been RF
exposure evaluated for use with this computer and may not
comply with FCC RF exposure requirements.
<Only for model with wireless LAN/wireless WAN/Bluetooth>
 This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment.
 This equipment has been approved for portable operation,
and does not require any minimum spacing be provided
between antennas and all person's body. If provided with
wireless WAN transmitter, requires LCD side panel spacers
to provide the following spacing between antenna located
within the LCD side panel, and all person's body (excluding
extremities of hands, wrist and feet) during wireless modes
of operation.
Model with MC7355 : minimum 16.7 mm
Model with other than MC7355 : minimum 1.5 cm
  This equipment may not be co-located or operated with any
other antenna or transmitter.
<Optional Car Mounter / Port Replicator>
 This equipment is provided with external antenna
connector(s) for connection to optional Car Mounter or Port
Replicator for mobile external mounted antenna(s). Exter-
nal antenna(s) must be professionally installed and cannot
exceed recommended maximum antenna gain as described
in individual provided supplement instructions for wireless
transmitters.
For WLAN, the Car Mounter should be used with Radiall/
Larsen WLAN whip antenna, type NMO5E2400BKTNC
with 5dBi antenna gain or less. Also, user must maintain
minimum 20 cm spacing between external antenna(s) and
all person's body (excluding extremities of hands, wrist and
feet) during wireless modes of operation.
<Only for model with wireless LAN>
This product is restricted to indoor use due to its operation in
the 5.15 to 5.25 GHz frequency range. FCC requires this prod-
uct to be used indoors for the frequency range 5.15 to 5.25 GHz
to reduce the potential for harmful interference to co-channel
Mobile Satellite systems. High power radars are allocated as
primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz
bands. These radar stations can cause interference with and/or
damage this product.
Responsible Party: Panasonic Corporation of North America
Two Riverfront Plaza
Newark, NJ 07102
Tel No:1-800-LAPTOP5 (1-800-527-8675)
Support Contact: http://www.panasonic.com/contactinfo
<Only for model with modem>
FCC Regulation Notice for modem
This equipment contains a FCC approved modem.
1. This equipment complies with CFR47 Part 68 rules.
On the computer is a label that contains, among other infor-
mation, the FCC registration number and ringer equivalence
number (REN) for this equipment. If required, this informa-
tion must be provided to the telephone company.
8
2. An FCC compliant telephone cord and modular plug is
provided with this equipment. This equipment is designed to
be connected to the telephone network or premises wiring
using a compatible modular jack which is Part 68 compliant.
See Installation Instructions for details.
3. The REN is used to determine the quantity of devices which
may be connected to the telephone line. Excessive RENs
on the telephone line may result in the devices not ringing in
response to an incoming call. In most, but not all area, the
sum of RENs should not exceed fi ve (5.0). To be certain of
the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone
company.
4. If your telephone equipment cause harm to the telephone
network, the telephone company will notify you in advice that
temporary discontinuance of service may be required. But
if advice notice isn't practical, the telephone company will
notify the customer as soon as possible. Also, you will be
advised of your right to fi le a complaint with the FCC if you
believe it is necessary.
5. The telephone company may take changes in its facilities,
equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone
company will provide advance notice in order for you to
make necessary modifi cations to maintain uninterrupted
service.
6. If trouble is experienced with this equipment, for repair or
warranty information, please contact Panasonic Corpora-
tion of North America at DIAL TOLL FREE 1-800-LAPTOP5
(1-800-527-8675). If the equipment is causing harm to the
telephone network, the telephone company may request that
you disconnect the equipment until the problem is resolved.
7. There are no user serviceable parts contained in this equip-
ment.
8. This equipment may not be used on coin service provided
by the telephone company. Connection to party lines is sub-
ject to state tariffs.
9. The Telephone Consumer Protection Act of 1991 makes it
unlawful for any person to use a computer or other electron-
ic device to send any message via a telephone fax machine
unless such message clearly contains in a margin at the top
or bottom of each transmitted page or on the fi rst page of the
25-M-1 transmission, the date and time it is sent and an identifi ca-
tion of the business or other entry, or other individual send-
ing the message and the telephone number of the sending
machine or such business, other entity, or individual. In
order to program this information into your fax software, you
should refer to the manual of the Fax software being used.
10. According to the FCC's electrical safety advisory, we rec-
ommend that you may install an AC surge arrestor in the
AC outlet to which this equipment is connected. Telephone
companies report that electrical surges, typically lightning
transients, are very destructive to customer terminal equip-
25-M-W
ment connected to AC power sources and that this is a
major nationwide problem.
"Caution : To reduce the risk of fi re, use only No.26 AWG or
larger (e.g., 24 AWG) UL listed or CSA certifi ed telecommunica-
tion line cord."
6-M-1 "ATTENTION : Pour réduire le risque d'incendie, utiliser unique-
ment des conducteurs de télécommunications 26 AWG ou de
section supérieure (p.ex. 24 AWG) UL énumérés ou CSA certi-
fi é."
UL1604-conforming model. (The model which has description of
"UL1604" in the bottom of the computer.)
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DI-
VISION2, GROUPS A, B, C, AND D OR NON-HAZARDOUS
LOCATIONS ONLY.
WARNING-EXPLOSION HAZARD-SUBSTITUTION OF COM-
PONENTS MAY IMPAIR SUITABILITY FOR CLASSI, DIVI-
SION2.
16-M-1