Installing The Heat Sink Assembly; Removing The Processor; Installing The Processor - Dell VOSTRO 3653 Owner's Manual

Installing the heat sink assembly

1. Place the heat sink assembly on the processor.
2. Tighten the captive screws to secure the heat sink assembly to the system board.
3. Connect the heat sink assembly cable to the connector on the system board.
4. Close the front bezel door.
5. Install the:
• bezel
• cover
6. Follow the procedure in

Removing the processor

1. Follow the procedure in
2. Remove the:
• cover
• bezel
3. Open the front bezel
4. Remove the heat sink
5. To remove the processor:
a. Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1].
b. Lift the lever upward and lift the processor shield [2].
c. Lift the processor out of the socket [3].
CAUTION: The processor socket pins are fragile and can be permanently damaged. Be careful not to bend the
pins in the processor socket when removing the processor out of the socket.

Installing the processor

1. Align the processor with the socket keys.
CAUTION: Do not use force to seat the processor. When the processor is positioned correctly, it engages easily into
the socket.
2. Align the pin-1 indicator of the processor with the triangle on the socket.
3. Place the processor on the socket such that the slots on the processor align with the socket keys.
4. Close the processor shield by sliding it under the retention screw.
5. Lower the socket lever and push it under the tab to lock it.
6. Install the heat sink assembly.
7. Close the front bezel door.
8. Install the:
After Working Inside Your
Before Working Inside Your
door.
assembly.
Computer.
Computer.
13