Operation - Polaris 2015 RZR XP 1000 EPS Owner's Manual

OPERATION

WARNING
Failure to operate the vehicle properly can result in a collision, loss of control,
accident or rollover, which may result in serious injury or death. Read and
understand all safety warnings outlined in the safety section of this owner's
manual.
Vehicle Break-in Period
The break-in period for your new POLARIS vehicle is the first 25 hours
of operation, or the time it takes to use the first two tanks full of
gasoline. Clutch and drive belt break-in periods vary depending on
operating conditions. See page 47.
No single action on your part is as important as a proper break-in period.
Careful treatment of a new engine and drive components will result in
more efficient performance and longer life for these components.
Perform the following procedures carefully.
NOTICE: Excessive heat build-up during the first three hours of operation will
damage close-fitted engine parts and drive components. Do not
operate at full throttle or high speeds during the first three hours of
use.
Use of any oils other than those recommended by POLARIS may
cause serious engine damage. We recommend the use of POLARIS
PS-4 oils for your 4-cycle engine.
Engine and Drivetrain Break-in
1. Fill the fuel tank with gasoline. See page 31. Always exercise
extreme caution whenever handling gasoline.
2. Check the oil level. See page 85. Add the recommended oil as
needed to maintain the oil level in the safe operating range.
3. Complete the New Operator Driving Procedures outlined on pages
52-53.
4. Avoid aggressive use of the brakes. See Brake System Break-in on
page 47.
5. Vary throttle positions. Do not operate at sustained idle.
6. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 48.
46