General Rules; Balance Checking - Axis B0.6D User Manual

8
_____________________________________________________________________________________________________________________

9. General rules

1. Before each measurement make sure that zero indicator is displayed. If zero
indicator does not displayed or "----" communicate appears, press →0← key
and wait until zero indication and zero indicator appears.
2. The scale is equipped with a tare equal to its range. To tare the scale press
→T← key (left or right). Storing a tare value does not extend measuring range,
but only subtracts it from a load placed on a pan. To make weight control easier
and to avoid range overdrawing, the scale is equipped with a load indicator
(graduated in percentages).
3. Weighing result should be read when the indicator "
stabilisation of a result.
4. When the scale is not used but it is necessary to be ready to work immediately, it
can be switched off by pressing I/
switched off to "standby" mode (signalled by the indicator "OFF" in version
with the LCD display). To switch the scale on press I/
immediately ready to operate maximum accuracy (after self tests).
5. Weighed sample should be placed in the centre of the pan.
Place the scale on a platform to avoid dropping weighed objects
on the pan.
Do not overload the scale more then 20% of maximum load (Max).
6. Protect the scale against dust, aggressive dusts and liquids. To clean the scale
wash it with water with soap and dry it afterwards.

10. Balance checking

It is advised to check scale indication accuracy before and after series of
measurement using any load with known weight.
To check the scale with legal verification use a calibration weight with valid
calibration certificate. In case permissible error is exceeded it is advised to contact
the nearest service to calibrate the scale.
USER MANUAL
key. The scale reading system is then
" lights, which signalises
key. The scale is