Safety Issues - Napoleon 9700 B series Installation And Operating Instructions Manual

62

2.0 SAFETY ISSUES

This furnace has been designed to deliver many years of effi cient, dependable service. With regular
maintenance, some of which requires the attention of a qualifi ed installer, service agency or gas supplier,
some of which you may do yourself, the furnace will operate satisfactorily over many heating seasons.
Please read this manual to familiarize yourself with safety procedures, operation, and routine maintenance
procedures. Figure 1 is provided to help identify the components of your furnace.
UM
FIGURE 1 - FURNACE COMPONENTS
1
3
14
13
15
8
16
10
22
LEGEND
1. Combustion Air Intake Fitting
2. Flame Roll-Out Switch (2)
3. Flame Sensor - located underneath
4. Two Stage Gas Valve
5. Supply Air High Temperature Limit
6. Vent and Drain (Assembly) Coupling
7. Drain for Recovery Coil (3)
8. Condensate Trap
9. Two Stage Integrated Furnace Control (IFC) 21. UV Light Bulb
10. Transformer for 24 VAC / 40 VA
11. Burner Assembly
12. Hot Surface Igniter (HSI)
FIRE OR EXPLOSION HAZARD - IF THE INFORMATION IN THESE INSTRUCTIONS
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION MAY RESULT, CAUSING
W415-1243 / A / 03.19.15
2
!
PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
Do not use this furnace if any part has been
under water. A fl ood-damaged furnace is
11
extremely dangerous. Attempts to use the
furnace can result in fi re or explosion.
12
A qualifi ed service agency should be contacted
4
to inspect the furnace and to replace all gas
controls, control system parts, electrical parts
5
that have been wet or the furnace, if deemed
6
necessary.
7
21
9
18
17
20
19
13. Two Speed Exhauster
14. Pressure Switch Assembly
15. Front Manifold Cover Pressure Tap (3)
16. PFC "Choke Coil" (used on ¾ and 1 Hp units only)
17. Door Switch and Junction Box
18. Blower Motor
19. Circulating Air Blower
20. UV Light Ballast
22. LED Trouble Light
WARNING
!
H25.0.1
H3.26