JVC MX-KA6 Series Service Manual page 8

MX-KA6
Removing the CD changer unit
Prior to performing the following procedures, remove
the top cover.
[Caution] Although the CD mechanism unit can be
removed without removing the CD tray
panel, it is still recommended to remove it
in order to prevent damage.
a. From the front panel side of this set, push in the
sections marked with arrows and pull out the CD
tray toward the front.
b. Remove the CD tray panel by pushing both of
its extremities upward in the direction of the
arrows.
c. Push the CD tray deep into the set.
1. Disconnect the cord wires from the CD PCB CN703
and CN203.
2. From the rear of the set, remove two screws E
three screws F and four screws G on the front
panel left and right side.
3. Handle the CD changer unit rear, take out the unit.
CD tray panel
1-8
(See Fig.6 to 9)
Fig.6
CD tray panel
Fig.7
Fig.8
CD changer
unit
Fig.9
E
Antenna
termianl
F
Aux
terminal
G