JVC MX-KA6 Series Service Manual page 16

MX-KA6
Removing the cassette deck heads
Prior to performing the following procedures, remove
the top cover and both sides board.
Also remove the CD changer unit.
Also remove the front panel assembly.
1. Remove six screws Z that retain the cassette deck
mechanism. (Fig.19)
2. Remove the cassette deck mechanism and place
it so that the front side faces up.
3. Remove the solder from the bottom side of the
head terminal and disconnect the wire.
4. Remove screw U that retains the head.
5. Remove screw V that retains the head.
6. Hold the head and slide it in the direction of the
arrow to remove it.
Removing the 3-pin regulator and bridge
diode
(See Q904, Q907, D901, D914 and Fig.28)
Prior to performing the following procedures, remove
the top cover and both sides board.
1. Remove two screws A that connect the heat sink.
2. Remove two screws W that connect the heat sink.
3. Remove the solder fixing the the 3-pin terminal regulator
Q904, Q907.
4. Remove the solder fixing the 4-pin bridge diode
(D901, D914).
1-16
(See Fig. 19 and 27)
Cassette deck mechanism
(Front side)
PB Head V U
Fig.27
W
Fig.28
V U REC/PB Head
A