JVC MX-KA6 Series Service Manual page 10

MX-KA6
<Disassembly of units and assembly
inside this set>
Removing the CD PCB
Prior to performing the following procedures, remove
the top cover.
Also remove the CD changer unit.
1. Disconnect the wires from CN603A, CN603B and
CN604 on the CD PCB, which is located on the
back side of the CD changer unit.
2. The four screws J that retain the CD PCB should be
removed.
3. Remove the CD PCB by pulling it toward the side
where the CN601 is located.
4. Using solder, short the CD pickup to connect to
short round.
[Caution] After re-connecting the wires, be sure to
remove the shorting solder from the GND
connection.
5. Disconnect the card wire from the connector CN601
on the main PCB and then remove the main PCB.
1-10
(See Fig.12 to 13)
CD PCB
J
Fig.12
CD PCB
CN601
Short round
Fig.13
J
J