Toshiba MMK-AP0057HP-E1 Service Manual page 42

Function to clear error
1. Clearing method from remote controller
How to clear error of outdoor unit
In the unit of refrigerant line connected by indoor unit of the remote controller to be operated, the
error of the outdoor unit currently detected is cleared. (Error of the indoor unit is not cleared.)
The service monitor function of the remote controller is utilized.
<Method>
1
CL
Push + buttons simultaneously for 4 seconds or more to change the mode to service
TEST
monitor mode.
2
Push button to set the CODE No. to [
TEMP.
3
The display of A part in the following figure is counted as "
0002 0002 0002 0001 0001 0001
0002 0002 0001 0001
" " → → → → → "
0000 0000 0000
0000 0000
When " " appear, the error was cleared.
∗ However counting from "
4
When pushing
TEST
How to clear error of indoor unit
The error of indoor unit is cleared by
(Only error of the indoor unit connected with wired remote controller to be operated is cleared.)
0000 0000 0000
0000 0000
" → → → → → " " with 5-seconds interval.
0005
" is repeated on the display screen.
button, the status becomes normal.
3
TEMP.
2
FILTER L L
RESET TEST
4
<Operation procedure>
1
Returns to normal status
FF FF FF FF FF
].
0005 0005 0005
0005 0005
ON / OFF
TIMER SET FAN MODE
TIME SAVE A A VENT
SET CL SWING/FIX UNIT LOUVER T
2 3 4
ON / OFF
button of the wired remote controller.
- 42 -
FILE NO. SVM-17046
0004 0004 0004 0003 0003 0003
0004 0004 0003 0003
" → → → → → " " → → → → → "
1
" → → → → →