Automatic Ice Maker - Viking VCSB5423 Use & Care Manual

Freezer
Wire Shelf Adjustment
You can easily adjust your freezer's shelves. To remove a shelf, simply tilt it up at the front,
releasing the hooks from the shelf support. Then, pull the shelf straight out. To replace,
guide the rear hooks of the shelf into the slots in the shelf supports. Then, tilt the shelf up
at the front until the hooks drop into the slots. Next, lower the front of the shelf to a level
position.

Automatic Ice Maker

The ice maker and slide-out ice drawer on your refrigerator are not adjustable, but the ice drawer slides forward for
easy access to ice.
After the refrigerator reaches normal temperature, the ice maker fi lls with water and begins operating. Under normal
conditions, the ice maker will produce seven to nine batches of ice per 24 hour period.
Note: Allow 24 to 48 hours after installation before looking for ice in your ice drawer.
You should discard the fi rst three full drawers of ice produced by your refrigerator,
and should also throw out the fi rst drawer full of ice your refrigerator produces after
extended periods of non-use.
During ice production, the ice maker arm raises and lowers. When the ice bin is
full, the ice maker arm automatically turns the ice maker off. To manually stop ice
production, raise the ice maker arm. You will hear a defi nite click when you have the
arm in the right position. The ice maker won't produce any more ice until you lower
the ice maker arm.
To avoid damage to ice maker, observe the following:
• DO NOT force ice maker arm down or up past stop position.
• DO NOT place or store anything in ice bucket.
CAUTION
12
On
Position
Ice
Maker
Arm
Off
Position