Unfolding The Handle; Installing The Discharge Chute - Toro 38600 Operator's Manual

Unfolding the Handle

1. Cut the plastic tie that secures the rotor control cable
(Fig. 2) to the handle.
4
3
2
1
Figure 2
1. Plastic tie
2. Rotor control cable
3. Control bar
Important
If you do not cut the plastic tie, the rotor
brake will not function properly.
2. Loosen the knobs and pull out the handle locks until the
upper handle rotates freely (Fig. 3).
5
4
Figure 3
1. Knob (2)
2. Cable guide
3. Traction drive cable
3. Position the upper handle as shown in Figure 4.
Figure 4
4. Fully insert the handle locks (Fig. 3).
5. Ensure that the cable guide is in position as shown in
Figure 3.
6. Tighten the knobs until they are snug.
5
m-5053
4. Traction drive cable
5. Handle
1
2
3
m-5072
4. Handle lock (2)
5. Upper handle (right side)
m-5046
Important
Ensure that the rotor control cable and the
traction drive cable are properly adjusted (Fig. 2). Refer to
Adjusting the Rotor Control Cable on page 12, and to
Adjusting the Traction Drive Cable on page 13.

Installing the Discharge Chute

1. Place the discharge chute over the chute ring, and align
the hole in the back of the discharge chute with the
center hole in the chute ring (Fig. 5).
2
1
Figure 5
1. Chute ring
2. Discharge chute
2. Insert a screw in the center hole of the chute ring from
the inside until the screw just passes through the hole in
the discharge chute (Fig. 5).
3. Insert the chute handle over the discharge chute, align
the center hole in the chute handle with the screw, and
fully insert the screw through the center hole in the
chute handle (Fig. 5).
4. Install a washer and a locknut on the screw, and tighten
the locknut until it is finger tight.
5. Align the remaining holes of the chute handle, the
discharge chute, and the chute ring, and insert the two
remaining screws through the holes from the inside of
the chute ring.
6. Install the washers and the locknuts on the screws, and
tighten the locknuts until they are finger tight.
7. Tighten all locknuts securely.
7
3
m-5049
3. Chute handle