Replacing The Spark Plug; Replacing The Drive Belt - Toro 38600 Operator's Manual

5. Remove the six bolts and locknuts that hold the scraper
in place (Fig. 16).
2
1
Figure 16
1. Carriage bolt (6)
2. Locknut (6)
6. Remove the old scraper.
7. Install a new scraper to the housing using the bolts and
the locknuts you previously removed.
8. Connect the wire to the spark plug.
9. Install the control panel.
10. Insert the key in the switch.

Replacing the Spark Plug

Use a NGK BPMR4A or equivalent spark plug. Install a
new spark plug before each season.
1. Stop the engine and wait for all moving parts to stop.
2. Remove the key from the switch.
3. Remove the two mounting screws that secure the
control panel to the housing (Fig. 17).
2
1
Figure 17
1. Control panel
4. Lift off the panel, allowing it to hang on the recoil rope.
3
m-5060
3. Scraper
m-5061
2. Mounting screws (2)
15
5. Lift up the shroud and disconnect the wire from the
spark plug (Fig. 18).
1
Figure 18
1. Shroud
6. Clean any debris from around the base of the spark
plug.
7. Remove the spark plug.
8. Examine the spark plug and replace it if it is cracked,
fouled, dirty, or if the electrodes are worn.
Important
Do not clean the electrodes because grit
could enter the cylinder and damage the engine.
9. Set the gap between the electrodes on the spark plug at
0.030 in. (0.76 mm) as shown in Figure 19.
Figure 19
1. 0.030 in. (0.76 mm)
10. Install the spark plug by hand and then torque it to
15 ft-lb (20.4 N m). If you do not have a torque wrench,
tighten the plug firmly.
11. Connect the wire to the spark plug.
12. Install the control panel.
13. Insert the key in the switch.

Replacing the Drive Belt

Inspect the drive belt before each season, and replace it if it
is worn or damaged.
1. Stop the engine and wait for all moving parts to stop.
2. Remove the key from the switch.
3. Disconnect the wire from the spark plug. Refer to steps
3 through 5 of Replacing the Spark Plug on page 15.
2
m-5062
2. Spark-plug wire
1
m-3215