Toro Snowthrower Safety - Toro 38600 Operator's Manual

When cleaning, repairing, or inspecting, make certain
that the rotor blades and all moving parts have stopped.
Do not run the engine indoors, except when starting it
and for moving the snowthrower in or out of the
building. Open the outside doors; exhaust fumes are
dangerous.
Do not clear snow across the face of slopes. Exercise
extreme caution when changing direction on slopes. Do
not attempt to clear steep slopes.
Never operate the snowthrower without proper guards,
plates, or other safety protective devices in place.
Never operate the snowthrower near glass enclosures,
automobiles, window wells, and drop-offs without
properly adjusting the snow discharge angle. Keep
children and pets away.
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
Look behind and use care when backing up with the
snowthrower.
Never direct the discharge at bystanders or allow
anyone in front of the unit.
Never operate the snowthrower without good visibility
or light. Always be sure of your footing, and keep a
firm hold on the handle. Walk; never run.
Maintenance and Storage
Check all fasteners at frequent intervals for proper
tightness to be sure that the equipment is in safe
working condition.
Never store the machine with fuel in the fuel tank inside
a building where ignition sources are present, such as
hot water and space heaters and clothes dryers. Allow
the engine to cool before storing in any enclosure.
Always refer to this operator's manual for important
details if the snowthrower is to be stored for an
extended period.
Maintain or replace safety and instruction labels when
necessary.

Toro Snowthrower Safety

The following list contains safety information specific to
Toro products or other safety information that you must
know.
Rotating rotor blades can injure fingers or hands. Stay
behind the handles and away from the discharge
opening while operating the snowthrower. Keep your
face, hands, feet, and any other part of your body or
clothing away from moving or rotating parts.
Before adjusting, cleaning, repairing, and inspecting the
snowthrower, and before unclogging the discharge
chute, stop the engine, remove the key, and wait for all
moving parts to stop.
Use a stick, not your hands, to remove obstructions
from the discharge chute.
Before leaving the operating position, stop the engine,
remove the key, and wait for all moving parts to stop.
Do not wear loose-fitting clothing that could get caught
in moving parts.
If a shield, safety device, or decal is damaged, illegible,
or lost, repair or replace it before beginning operation.
Also, tighten any loose fasteners.
Do not smoke while handling gasoline.
Do not use the snowthrower on a roof.
Do not touch the engine while it is running or soon after
it has stopped because the engine may be hot enough to
cause a burn.
Perform only those maintenance instructions described
in this manual. Before performing any maintenance,
service, or adjustment, stop the engine, remove the key.
If major repairs are ever needed, contact your
Authorized Service Dealer.
Do not change the governor settings on the engine.
When storing the snowthrower for more than 30 days,
drain the fuel from the fuel tank to prevent a potential
hazard. Store fuel in an approved fuel container.
Remove the key from the ignition switch before storing
the snowthrower.
To ensure the best performance and safety, purchase
only genuine Toro replacement parts and accessories.
4