Applicable Controls - Toshiba MMK-AP0157HP-E Service Manual

SMMS High-Wall Type

11 APPLICABLE CONTROLS

A wired remote controller is necessary for this function. This function cannot be operate with a wireless
remote controller.
REQUIREMENT
time, it takes approx. 5 minutes until the remote
controller becomes available after power-on.
This is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
on flashes
<When power is turned on for the second (or
later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
flashes
on
unit was shipped from factory.
settings.
wireless remote controller, sub remote
controller, or remote-controller less system
Therefore, install the wired remote controller
to change the settings.
1111058602_EN.indd 27
Approx. 5 minutes
Remote
goes out controller is
available
Approx. 1 minutes
Remote
goes out controller is
available
- 95 -
FILE NO. SVM-18070
Changing of settings of for
applicable controls
Basic procedure for changing settings
The display content for setting differs from that on
the former types of remote controller the former types of remote controller (RBC-
(RBC-AMT21E/AMT31E).(The number of CODE
No. has increased.)
4
6
1 5
1
Procedure
Push button and "TEMP."
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure.
erase the display content, and repeat the
is pushed, the indoor unit number
Installation Manual
Installation Manual
1
3
2
button
11/24/16 11:41 AM 11110586