Installation - Electrolux GHS607S User And Installation Manual

technical data
FEATURES WHG641SA WHG643SA
Brand Westinghouse Westinghouse
Cooking zones 4 4
Wok Yes Yes
Ignition 220-240V 220-240V
Trivet Wire Matt Wire Matt
Hob material Stainless Steel Stainless Steel
Features Ignition through knob Ignition through knob
Flame safeguard No Yes
NG, (LP conversion NG, (LP conversion
Gas Types
kit supplied)
kit supplied)
Cooktop dimension
Width (mm) 600 600
Depth (mm) 535 535
Height (mm) 58 58
Cutout dimension
Width (mm) 570 570
Depth (mm) 490 490
Energy rating (NG)
Small burner 5.1 MJ/h 5.1 MJ/h
Medium burner 9.0 MJ/h 9.0 MJ/h
Large burner 12.1 MJ/h 12.1 MJ/h
Wok burner 14.4 MJ/h 14.4 MJ/h
Total MJ/h 40.6 MJ/h 40.6 MJ/h
10 TECHNICAL DATA Gas Cooktops
WHG645SA/WA WHG951SA WHG955SA/WA
Westinghouse Westinghouse Westinghouse
4 5 5
Yes Yes Yes
220-240V 220-240V 220-240V
Cast Iron Wire Matt Cast Iron
Stainless Steel/ Stainless Steel/
Stainless Steel
Enamelled White Enamelled White
Ignition through knob Ignition through knob Ignition through knob
Yes No Yes
NG, (LP conversion NG, (LP conversion NG, (LP conversion
kit supplied) kit supplied) kit supplied)
600 860 860
535 510 510
58 58 58
570 830 830
490 470 470
5.1 MJ/h 5.1 MJ/h 5.1 MJ/h
9.0 MJ/h 2 x 9.0 MJ/h 2 x 9.0 MJ/h
12.1 MJ/h 12.1 MJ/h 12.1 MJ/h
14.4 MJ/h 14.4 MJ/h 14.4 MJ/h
40.6 MJ/h 49.6 MJ/h 49.6 MJ/h

installation

Table 2
Cooktop dimensions Square Rectangular
width (mm) 600 860
depth (mm) 535 510
height (mm) 58 58
Cut-out dimensions
width (mm) 570 830
depth (mm) 490 470
caution
WARNING
Cooktops are supplied for use with natural gas (NG). To use with
LPG, the injectors MUST be changed using the conversion kit
supplied. Refer LP Conversion on page 13 and 15).
This appliance must be installed by an authorised person and in
compliance with:
1. AS/NZS 5601.1 Gas Installations Part 1: General
Installations, and AS/NZS 5601.2 Gas Installations Part 2:
LP Gas installations in caravans and boats for non-propulsive
purposes, or the relevant installation code for gas appliances
in your country.
2. The local gas fitting regulations, municipal building codes,
electrical wiring regulations and any other relevant statutory
regulations.
3. The particular instructions as given below. Before commencing
installation, check to ensure that the appliance gas type given
on the data plate on the appliance corresponds with the type
of gas to which it is intended the appliance be connected.
4. A certificate of compliance MUST be given to the customer
after the application is successfully installed.
5. This appliance must be earthed (240V models only).
Installation procedure
1. The bench cutout should be made as per cutout dimensions in
Table 2 and Figure 4.
2. Adjacent walls, cupboards and protection for combustible
materials: Ensure that the appliance is installed in accordance
with clauses 6.2.5 and 6.10.1.1 of AS/NZS 5601.1, or
clauses 6.9.1 and 6.9.5 of AS/NZS 5601.2 with regard
to clearances to combustible surfaces and materials, and
clearances to rangehoods and exhaust fans.
To ensure clearances of 200mm from burners to vertical
combustible surfaces observe the minimum distance
requirements shown in Figure 5.
Clearances to combustible surfaces may be reduced if
combustible surfaces are protected in accordance with clause
6.10.1.2 of AS/NZS 5601.1, or clause 6.9.2 of AS/NZS
5601.2.
NOTE: For installation into a standard 600mm width
benchtop the clearance specified can not be achieved
and combustible surfaces must be protected in
accordance with the above clauses.
3. Optional barrier: A barrier can be installed to prevent
accidental contact with the cooktop base, where the base of
the cooktop is accessible from below (i.e. Inside a cupboard,
etc.). An impression has been incorporated into the base to
ensure a minimum clearance of 10mm is maintained between
the base and the barrier. This barrier may be made of any
rigid material.
Barrier protection is not necessary if the product is installed
above an underbench oven or similar appliance and/or if
the cupboard construction is such that the underside of the
cooktop is not accessible.
Figure 4
37mm
130mm min
490mm
570mm
19mm
gas supply
connection
27mm
135mm
min
470mm
830mm
19mm
gas supply
connection
Gas Cooktops INSTALLATION 11
130mm min
120mm min