MICROclimate International B2/HT User Manual

Correct temperature reading
The temperature sensor encased in the black sheath is very accurate.
Having set the desired temperature on the thermostat and positioned
the sensor in its required location the temperature of the air will be
controlled accurately at the position of the temperature sensor.
The temperature nearer the heater (from the sensor position) will be
hotter and further away from the heater it will be cooler.
Please note that when using a thermometer to check the temperature
that unless it is in exactly the same position as the thermostat sensor
there will be a discrepancy due to the positioning of the thermometer.
Warranty
Used in accordance with these instructions this thermostat will give
many years of trouble free service.
The thermostat is guaranteed for five years from the date of purchase
against faulty parts and workmanship. In the unlikely event of a
failure, return it to Microclimate International Ltd and together with a
receipt or proof of purchase and a brief description of the fault. If
returned within one year there will be no charge, after this time a
charge of £5 will be made for administration and postage. Please
enclose a cheque or postal order made payable to Microclimate
International. C ash is also accepted.
No liability is accepted other than for the repair or replacement of a
faulty product.
This does not affect your statutory rights.
Microclimate International
Unit 3 Heath Mill Enterprise Park
Heath Mill Road
Wombourne
England
United Kingdom
WV5 8AP
Tel : 01902 895351
Fax : 01902 897613
Sales@microclimate.co.uk
www.microclimate.co.uk
IMPORTANT -­‐ T O ENSURE C ORRECT O PERATION O F Y OUR B 2/HT T HERMOSTAT
PLEASE READ T HE G UIDE BEFORE C OMMENCING INSTALLATION
B2/HT T hermostat
The B2/HT T hermostat is designed to give precise microprocessor
controlled temperature of non light emitting heat sources up to 600
watts. T his may include heatmats and ceramics. T he heater must be a
minimum of 5 watts.
The B2/HT is a pulse proportional thermostat which pulses the power
to the heat source. For this reason pulse proportional thermostats are
not suitable for light emitting heaters i.e bulbs.
WARNING
DO NOT OVERLOAD YOUR THERMOSTAT BY CONNECTING
HEAT SOURCES WITH OUTPUTS GREATER THAN 600 WATTS.
DAMAGE CAUSED BY MISUSE IS NOT COVERED BY THE WARRANTY.
B2/HT T hermostat
User G uide
PF0077HT A