Table of Contents
Advertisement
Variable-speed
Pulley
Single-speed
Transmission
NOTE:
View shown from above tractor.
Adjust the drive pedal after replacing the drive belts on
your tractor, if necessary, as follows:
•
Locate the speed control assembly on the
underside of the steering support bracket. See
Figure 17.
•
Remove both hairpin clips from the pin which is
fastened to the speed control assembly (be careful
not to lose the small flat washers found on the pin).
See Figure 17.
•
Remove the drive pedal return spring.
Using two 9/16" wrenches, remove the pin from the
speed control assembly. See Figure 17.
Thread the idler adjustment rod inward or outward to
lengthen or shorten the travel of the double-idler
bracket until proper adjustment is achieved.
•
Reassemble by following the above steps in
reverse order.
Battery Tray
Shift Lever
Opening
Belt Keeper
Idler Bracket
Transmission Idler Pulley
Transmission Pulley
Figure 16
Rear Idler Pulley
Front Idler Pulley
Keeper Pins
to drive pedal
Double-Idler Bracket
Front of Tractor
Idler Adj. Rod
Neutral
Return
Bracket
Hairpin
Clips
Drive Pedal
Return Spring
21
Drive belt (Lower)
Drive belt (Upper)
Engine Pulley
Place Wrenches Here
Pin
Speed Control
Assembly
Figure 17
Advertisement
Table of Contents
