Martin MAC 401 Dual User Manual page 40

Menu Item
INFO
(continued)
REAR
(continued)
MAN
TEST
PTST
FANS
PERS
DIM
DRES
DISP
DINT
40
Item Options
CURR
PTMP MSR
MR
TOTL
AIRF
STTM
RDM
SNUM
SNUM
RST
ALL 0 255
–
RED
or
0 255
–
WARM
GRN1 0 255
–
GRN2 0 255
–
BLUE
or
0 255
–
COLD
ZOOM 0 255
–
TILT 0 255
–
PAN 0 255
–
TALL
T-FX
TP-T
TDIS
PTSP
SWAP
PINV
TINV
REG
FULL
SLNT
LIN
SQR
ISQR
SCUR
OFF
ON
ON
2MN
5MN
10MN
0-100
Table 7: Control menu: dual head module operation
MAC 401™ user manual
Notes (Default settings in bold print)
Display current average pixel PCB temperature
Display highest pixel PCB temperature since last reset
Display highest pixel PCB temperature since manufacture
Current elapsed time in hours since the air filter was cleaned or
changed. Display the counter and press the up button for five seconds
to reset it.This counter must be reset manually when the air filter is
cleaned.
Set duration of time alert to be issued after 100-9999 hours have
TOTL
passed on the counter, to remind you to clean it, particularly the
air filter. The alert appears as long as the value of the
higher than the threshold set here.
Display fixture's RDM ID (this will be the same in the
Display fixture's serial number (this will be the same in the
menu)
Reset fixture. Press [Enter] to confirm
All LEDs, intensity 0 - 100%
Red if RGB module installed, Warm white if CT module installed,
intensity 0 - 100%
Green 1 if RGB module installed, intensity 0 - 100%
Not displayed if CT module installed
Green 2 if RGB module installed, intensity 0 - 100%
Not displayed if CT module installed
Blue if RGB module installed, Cold white if CT module installed,
intensity 0 - 100%
→
Zoom full wide zoom full narrow (Hypermode)
→
Full tilt full opposite tilt
→
Pan full left pan full right
Test LEDs, zoom and pan/tilt movement
Test LEDs and zoom only
Test pan/tilt movement only
Light all segments in onboard display panel for 5 secs.
Pan and tilt speed normal / fast
Swap pan and tilt (pan commands move tilt and vice versa) - off / on
Pan inversion (reverse direction pan control) - off / on
Tilt inversion (reverse direction tilt control) - off / on
Cooling fan speed thermostatically regulated
Max. cooling fan speed
Silent mode. When Silent mode is selected the head fan will turn off.
The base fan will still run. Values allowed for RGB or HSV (no matter
what operating mode) will be limited to prevent the fixture from
producing too much heat. If the LEDs get too hot the fans will revert to
Regulated mode. When the LEDs are cool enough the fans shift back to
Silent mode. The color wheel channel will have lower intensity in Silent
mode.
Linear dimming curve
Square law dimming curve
Inverse square law dimming curve
S-curve dimming curve
Disable reset via DMX
Enable reset via DMX
Display is always on
Display switches off and goes into Sleep mode if the controls have
not been pressed for 2 minutes.
Display switches off and goes into Sleep mode if the controls have not
been pressed for 5 minutes
Display switches off and goes into Sleep mode if the controls have not
been pressed for 10 minutes
Display intensity. Default=100
TOTL
counter is
FRNT
menu)
FRNT