Lamp Replacement - Sanyo PDG-DXL2000 Service Manual

Maintenance

Lamp Replacement

When the projection lamp of the projector reaches its end
of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow. Replace the
lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp
mode.
WArNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
CAutION
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be bro-
ken. If replacing the lamp of a projector which has been installed on the ceiling, you should always assume
that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the
lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get
into your eyes or mouth, seek medical advice immediately.
CAutION
Allow a projector to cool for at least 45 minutes
before you open the Lamp Cover. The inside of
the projector can become very hot.
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC power cord. Let
the projector cool for at least 45 minutes.
2
Loosen the screw and open the lamp cover.
3
Loosen the two (2) screws that secure the lamp. Lift the
lamp out of the projector by using the handle.
4
Replace the lamp with a new one and secure the two (2)
screws. Make sure that the lamp is set properly. Close
the lamp cover and secure the screw.
5
Connect the AC power cord to the projector and turn on
the projector.
6
reset the lamp counter.
See "Resetting the Lamp Counter" on the next page.
OrDer rePLACeMeNt LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
replacement Lamp type No.
Service Parts No.
top Panel
Lamp replacement icon
Note:
The Lamp replacement icon will not appear when the
Display function is set to Off, during Freeze, or No show.
CAutION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Screws
: POA-LMP143
: 610 351 3744
-8-
This indicator turns yellow
when the projection lamp
reaches the end of its life.
Lamp Cover
Screw
Lamp
Handle