Sanyo PDG-DXL2000 Service Manual page 21

Mechanical Disassembly
⁄0 Note on wiring
After disassembling the mechanical parts or electrical parts, the wiring cables
must be placed in the original position.
Especially the cable dressing indicated in the figure below, use a fixer not to
touch the cable to the parts on the primary power circuit.
Fig.9
Fix the cables connected to SW902
by using a fixer not to touch the radia-
tor on the ballast board.
Fix the cables by using a fixer not
to touch the radiator on the ballast
board.
-21-