Table of Contents
Advertisement
Resistance and Continuity Measurements
1. Set the Function/Range switch to the desired resistance range or continuity
position.
2. Remove power from the equipment under test.
3. Connect the red test lead to the "VW " jack and the black test lead to the
"COM" jack.
4. Touch the probes to the test points. In ohms, the value indicated in the
display is the measured value of resistance. In continuity test, the beeper
sounds continuously, if the resistance is less than 100W .
WARNING
The accuracy of the functions might be slightly affected, when exposed to
a radiated electromagnetic field environment, eg, radio, telephone or
similar.
9
Advertisement
Table of Contents
