Installation Requirements; Tools And Parts; Location Requirements - KitchenAid 720-0891B Installation Instructions And Use & Care Manual

Tools and Parts

Gather these required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
 Phillip screwdriver
 Wrench or pliers
 Pipe wrench
Parts Supplied
■ Gas pressure regulator/hose assembly set for 11" WCP LP
gas
■
See "Package parts list"

"AA" Battery (1)

Natural gas orifice for main burner
Parts Needed

20 lb LP gas fuel tank-approximately 18" (45.7cm) height.
Parts Needed for Conversion to Natural Gas
Natural gas conversion kit Part Number 710-0003. See
"Assistance" section to order. The conversion kit includes:
 Natural gas regulator 4" W.C. (marked "Natural Gas
Regulator")
 10 ft (3.0 m) Natural gas hose with quick connector
 5.9" (150 mm) Natural gas regulator hose
 6 mm nut driver
 6 mm wrench
 Hex key
 Gas line shutoff valve
 1/2" male pipe thread nipple for connection to pressure
regulator.
 LP gas-resistant pipe-joint compound
 CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed.

INSTALLATION REQUIREMENTS

 Noncorrosive leak-
detection solution

Location Requirements

Select a location that provides minimum exposure to wind
and traffic paths. The location should be away from strong
draft areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for grill:
 A minimum of 24" (61 cm) must be maintained between
the front of the grill hood, sides and back of the grill
and any combustible construction.
 A 24" (61 cm) minimum clearance must also be
maintained below the cooking surface, and the grill
shall not be used under overhead combustible
construction.
5