First Time Setup - Panasonic Viera TC-L32X2 Operating Instructions Manual

First Time Setup

First time setup screen is displayed only when the TV is turned on for the first time after the power cord is
inserted into a wall outlet and when "Auto power on" (p. 29) is set to "No".
Turn the TV On with the POWER button
(TV)
or
Configure your viewing mode
Select your language
Language / Idioma / Langue
English Español
Select your viewing mode
Set viewing mode
Home Use
OK
Select
RETURN
Please confirm your selection (Home Use) before pressing OK button.
If you select "Store Demonstration" by mistake in
confirmation screen will be displayed.
You are selecting the store demonstration mode.
Yes
If you select "Yes", the picture mode will regularly reset
to "Vivid" and a Picture Refresh message will be displayed on the
screen.
Select "No" and return to previous screen
If you select "Yes", Screen enters the store demonstration mode.
To display the "Set viewing mode" screen again as shown above and select
"Home Use", do one of the following:
• Press and hold down the side POWER button for at least five seconds.
• Unplug power cord for 30 seconds and plug it again.
Note
is not available on
is not available on
When you have used
"Language" settings will be displayed.
If you use any other step other than
button to quit before completing the settings, the next time you turn the TV on "First
time setup" will not be automatically displayed.
• The settings up to that point are saved.
• You can reset the settings using "First time setup". (p. 29)
To change the setting (Language, ANT/Cable setup, Input labels, Clock) later, go to
the Menu screen (p. 29)
12
(Remote)
or
select
Français
OK
(Be sure to select "Home use")
Step 2 of 6
select
Store Demonstration
OK
Please select your viewing environment.
Select "Home Use" when using this TV in your
home.
select
No
OK
.
.
-
.
to turn the TV off, the next time you turn the TV on the
to turn the TV off, or if you used the EXIT
,
Press to return to
the previous screen
Auto channel setup (ANT/Cable setup)
Select the connected Antenna in terminal
ANT/Cable setup Step 3 of 6
Cable Antenna Not used
select
ANTENNA
Cable In
OK
ANTENNA
Cable In
OK
Select "Not used" when viewing TV via
Select Satellite receiver or Cable box. Note: Select
RETURN
"Cable" when viewing via Cable DTA Box.
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
Typical when a Cable/Satellite box is connected to a TV input.
Prevents accidental tuning to an unavailable signal.
Select "Start"
Auto program Step 4 of 6
select
Start Skip
OK
OK Start scanning for channels via the TV's
built-in tuner. Select "Skip" when viewing TV
Select
RETURN
channels via Satellite receiver or Cable box.
Start scanning the channels
(Available channels are automatically set.)
Auto program
Progress 8%
Number of analog channels 10
Number of digital channels
0
Press RETURN to quit
RETURN
Complete the Auto program setup
Completion message is displayed when the Auto program scan is successfully
completed.
Auto program
OK
Number of analog channels 10
Number of digital channels
0
Auto program completed.
Press OK to continue.
OK
RETURN
Operation of the EXIT button during "First time setup"
Press the button once to display confirmation screen. Press again to close
confirmation screen.
[EXIT confirmation screen]
Yes Exit "First time setup"
Are you sure you want to exit the First Time Setup?
No Return to the original screen.
Yes No
To repeat the First Time Setup, select
"First time setup" in the Setup Menu.
Not used: Go to
(Label inputs)
Skip: Go to
(Label inputs)
If there is no available
channel, return to -
(ANT/ Cable setup).
"Not used" will be selected.
13