Table of Contents
Advertisement
Adjusting your monitor image
Using the direct access controls
Using the On-Screen Display (OSD) controls
2-3 ThinkVision Pro2820 Flat Panel Monitor User's Guide
This section describes the user control features used to adjust your monitor image.
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Note: The direct access controls are gray.
Table 2-1. Direct access controls
Icon
Control
Input Change
Image Setup
Brightness
Main menu
The settings adjustable with the user controls are viewed through the On-Screen Display (OSD),
as shown below.
To use the controls:
1.
Press
to open the main OSD menu.
2.
Use
or
to move among the icons. Select an icon and press
function. If there is a sub-menu, you can move between options using
press
to select that function. Use
save.
3.
Press
to move backwards through the sub-menus and exit from the OSD.
4.
Press and hold
for 10 seconds to lock the OSD. This will prevent accidental adjustments
to the OSD. Press and hold
the OSD.
5.
Enables DDC/CI by default. Use OSD Exit Key, press and hold the
disable/enable DDC/CI function. The words " DDC/CI Disable/DDC/CI/Enable" shows on the
screen.
Description
Switches the video input source.
Activates automatic image adjustment.
Direct access to Brightness adjustment.
Open main OSD menu
or
to make adjustments. Press
for 10 seconds to unlock the OSD and allow adjustments to
to access that
or
, then
to
buttons for 10 seconds to
Advertisement
Table of Contents
