Horizon Fitness Horizon Series User Manual page 5

U N FO L DIN G
The treadmill was folded in the carton
when purchased. Follow these steps to
unfold the treadmill.
1. Press and hold both LOCK BUTTONS
with your thumbs.
Carefully lift the CONSOLE MODULE
2.
upward until it is in the upright
position.
3. Pull the LOCKING BAR upward until
it is tight.
4. Gently pull the FRONT HANDLEBAR
downward.
CAUTION:
Do not use the treadmill if the
LOCKING BAR is not tight.
FO L DIN G
Follow these steps to fold the treadmill.
1. Gently pull the FRONT HANDLEBAR
upward.
2. Pull the LOCKING BAR downward to
release the lock.
Carefully pull the CONSOLE MODULE
3.
downward until it rests flat on the
treadmill deck.
4. Press down on the CONSOLE
MODULE until both locks engage.

Evolve_SS_Treadmill_Rev.1.5.indd8-9 8-9
4
2
1
1
3
4
MOVING AND STORAGE
Our treadmills can be heavy. Use care and additional help if necessary when
WARNING
moving. Do not attempt to move or transport treadmill unless both the lock
latches are secured. Failure to follow these instructions could result in injury.
MOVING / STORAGE
This treadmill has a pair of transport
wheels built under the base frame. To
move, make sure the treadmill is folded
down and securely latched. Then, firmly
grasp the lifting handlebar, lift the
treadmill up and roll. This treadmill can
be stored horizontally (under a bed) or
vertically (against a wall).
3
To store underneath a bed, firmly grasp the lifting bar and
move the treadmill. Gently lower and push the treadmill
under the bed. (See illustration above)
CAUTION:
To prevent damage to the treadmill, make sure the area has
enough space to store the treadmill.
This treadmill is equipped with two STABILIZER LEGS on the front
side. To store the treadmill vertically, follow these steps:
1. To stand the treadmill up, pull the STABILIZER LEGS outward.
2. Turn the STABILIZER LEGS so they face upward.
3. Push the STABILIZER LEGS back in to lock them in place.
4. Place the treadmill close to wall with the STABILIZER LEGS
facing the wall. Carefully lift the treadmill up using the
LIFTING BAR.
5. Pull the STABILIZER BRACKET upward.
6. Rotate the STABILIZER BRACKET down all the way to the floor.
The STABILIZER BRACKET will automatically lock in place.
2
7. To put the treadmill back down, pull the STABILIZER BRACKET
towards you and rotate it upward until it locks.
8. Follow the steps above in reverse order to completely put the
treadmill back down.
2
STABILZER LEG
1
3
LIFTING BAR
4
5
STABILZER
BRACKET
6

6/23/08 2:43:14 PM