Display Fault/Error Codes For Steam Dryer - LG DLEX3250 Series Service Manual

Cannot see steam
vapor at the
beginning of cycle.
The display shows
BULKY LOAD.
Odors remain in
clothing after
STEAM FRESH™.

8-3. Display Fault/Error Codes for Steam Dryer

The error codes below will be displayed when attempting to start a drying cycle or after
activating the Diagnostic Test mode.
Thermistor of blower
tE1
housing
Thermistor of blower
tE2
housing
Thermistor of steam
tE4
generator
E5 Water supply pump
Add water
Steam generator
• This is normal.
• MORE TIME button
pressed.
• STEAM FRESH™ did
not remove odor
completely.
Outlet thermistor open or shorted.
Outlet thermistor open or shorted.
Steam generator thermistor open
or shorted.
When the pump valve is less than
10 in the test mode
Sensors do not detect that steam
generator is full within 60 seconds.
• Steam is released at different stages of the cycle
for each option.
• Pressing the MORE TIME button several times will
set the cycle for a large load such as a comforter.
• Fabrics containing strong odors should be washed in
a normal cycle.
• tE1 error is displayed in the
• tE2 error is displayed in the
• tE4 error is only displayed in the
• Replace the steam generator.
• tE5 error is only displayed in the
• Check the connection between
• Replace the water supply pump.
• If water in the steam feeder is
22
drying cycle or test mode.
drying cycle or test mode.
test mode.
test mode.
harness wire and connector.
not enough this error may be
displayed. Fill the feeder and
restart the cycle.