Changes Not Saved; Troubleshoot With The Leds; Apply Power To The Router And Check The Leds - NETGEAR JNR1010v2 User Manual

- Does your computer or wireless device support the security that you are using for
your WiFi network (WEP, WPA, or WPA2)?
For information about wireless security settings, see
page 33.
- Did you set up a wireless access list in the router?
If you set up an access list, you must add the MAC address for each computer and
wireless device to the list. For more information about access list settings, see
a Wireless Access List

Changes Not Saved

If the router does not save the changes you make through the NETGEAR genie screens,
check the following:
• When you log in to the router and change the settings on a screen, always click the Apply
button before you move to another screen or tab, or your changes are lost.
• Click the Refresh or Reload button in the web browser. The changes might have
occurred, but the old settings might be in the web browser's cache.

Troubleshoot with the LEDs

The LEDs on the front panel of the router indicate its status.

Apply Power to the Router and Check the LEDs

To apply power to the router and check the LEDs:

1. Connect the power adapter cord that came with the router and plug it in to a power
outlet.
The Power LED lights and turns amber within a few seconds. This indicates that the
self-test is running.
2. After approximately 30 seconds, verify that the LEDS are lit as follows:
• The Power LED
• The WiFi LED
• The Internet LED
• The Ethernet LEDs (1 through 4)
any computers cabled to the router by an Ethernet cable.
3. If the LEDs do not light as expected, use the LED behavior to troubleshoot the problem.
N150 and N300 Wireless Routers
on page 40.
is lit solid green.
is lit solid green.
is lit solid green.
Troubleshooting
67
Specify Basic WiFi Settings
are lit solid green or solid amber for
on
Set up