Trouble Shooting; Eu Conformity Declaration - Makita DCS4630 Instruction Manual

Trouble shooting

Malfunction
Chain does not run
Engine does not start or
only with difÞ culty
Warm start difÞ culties
Engine starts, but
dies immediately
InsufÞ cient power
No chain lubrication

EU Conformity Declaration

The undersigned, Tomoyasu Kato, as authorized by MAKITA Corporation, declare that the MAKITA machines,
Type: 180, 181
Chain saw
DCS4630 (180)
DCS5030, 5032 (181)
EA5000P, 5001P (181)
manufactured by MAKITA Corporation, 3-11-8 Sumiyoshi-Cho, Anjo, Aichi, 446-8502 Japan, conforms to the basic safety and health
requirements of the applicable EU Directives:
EU Machinery Directive 2006/42/EG, EU EMC Directive 2004/108/EG, Outdoor Noise Directive 2000/14/EG.
The most important standards applied to properly meet the requirements of the above EU Directive were: EN 11681-1, EN ISO
14982, CISPR 12.
The conformity assessment procedure 2000/14/EG was performed per Annex V. The measured noise level (L
guaranteed noise level (L
d
The EU-Type-Examination CertiÞ cate was performed by: DEKRA Testing and CertiÞ cation GmbH (2140), Enderstraße 92 b, D-01277
Dresden. The technical documentation is on Þ le at MAKITA International Europe Ltd., Michigan Drive, Tongwell, Milton Keynes, Bucks,
MK15 8JD, England.
Anjo, 16.12.2011
For MAKITA Corporation
Tomoyasu Kato
Managing Director
System
Chain brake
Ignition system
Fuel supply
Compression
system
Mechanical
malfunction
Carburetor
Fuel supply
Several systems
may be involved
simultaneously
Oil tank/pump
EU prototype test certiÞ cate No.
4811004.11010
4811004.11010
4811004.11010
) is 112 dB(A).
Observation
Engine runs
Ignition spark
No ignition spark
Fuel tank is Þ lled
Inside
Outside
Starter does not engage
Fuel tank is Þ lled
Ignition spark
Fuel tank is Þ lled
Engine is idling
No oil on the chain
Cause
Chain brake actuated.
Malfunction in fuel supply system, com-
pression system, mechanical malfunction.
Switch on STOP, fault or short-circuit in the
wiring, plug cap or spark plug defective.
Combination switch in Choke position,
carburetor defective, suction head dirty, fuel
line bent or interrupted.
Cylinder base packing ring defective, radial
shaft packings defective, cylinder or piston
rings defective
Spark plug does not seal.
Spring in starter broken, broken parts
inside the engine.
Wrong carburetor adjustment.
Wrong idling adjustment, suction head or
carburetor dirty.
Tank venting defective, fuel line interrupted,
cable defective, Combination switch defective
Air Þ lter dirty, wrong carburetor adjustment,
mufß er clogged, exhaust channel in cylinder
clogged, spark arrester screen clogged.
Oil tank empty.
Oil guide groove dirty.
Oil-pump adjusting screw incorrectly adjusted.
) is 111 dB(A). The
wa
29