Installing Additional Software; Scanner Setup After Windows Xp Upgrade - Plustek OPTICPRO ST64 User Manual

• The rectangular end of the USB cable is plugged into the back of your
computer.
If you deviated from the installation procedures defined in this manual, please
unplug the USB cable from the scanner and reinstall the software from the CD-ROM.
To reinstall your scanner's software, click [Start] | [Run], then type [D:\Setup] (where
D represents the letter of your CD-ROM drive). Carefully follow all the installation
instructions presented in the Setup Wizard. Reboot your computer when prompted,
and plug the USB cable back into the scanner while your computer is still turned on.

Installing Additional Software

Your scanner is TWAIN compliant and functions with virtually all available
TWAIN compatible software. If you purchase additional software to be used with
your scanner, please make sure that it conforms to the TWAIN standard.

Scanner Setup After Windows XP Upgrade

If you plan to upgrade your operating system from Windows 98 or Me to
Windows XP after having installed the scanner software, please follow the
instructions below:
1. Unplug the scanner's AC power adapter from the electrical outlet.
2. Unplug the scanner's USB cable from the rear of the computer.
3. From the Windows [START] menu, point to [Programs] and then [Your
scanner model name]. In the pop-up menu that opens, click on [Uninstall
USB Scanner]. Follow the on-screen instructions to remove all the scanner
software.
4. After uninstallation completes, close all open applications and click the
[Finish] button to restart your computer.
5. Start installing your Windows XP upgrade software by following Microsoft's
related procedures.
6. When the Windows XP upgrade is done, re-install the scanner's hardware
and software. Refer to the scanner setup quick guide for details.
8