Central Pneumatic 61615 Owner's Manual & Safety Instructions page 11

7. Make sure the air tool's throttle or switch is in the
off position. Connect the air tool to the air hose.
8. Open the in-line Shutoff Valve.
Note: Allow adequate time when filling tires.
The larger the tire, the more time to fill is needed.
Note: This product is designed for inflation,
stapling, brad nailing and air brushing.
9. Use the air tool as needed.
10. After the job is complete, turn the Power Switch OFF.
Emergency Depressurization
If it is necessary to quickly depressurize the Compressor, turn the Power Switch OFF.
Then, pull on the ring on the Safety Valve to quickly release stored air pressure.
Automatic Shut off System
1. If the Compressor automatically shuts off
before reaching its normal cutoff pressure:
a. Shut off all tools.
b. Wait until the Compressor cools down
(about 10 minutes);
c. If the unit does not start up again on its own,
check the Fuse next to the switch
and replace as needed;
d. Resume operation.
Item 61615 For technical questions, please call 1-888-866-5797.
11. Unplug the Air Compressor.
12. Close the in-line Shutoff Valve.
13. Bleed air from the tool then disconnect the tool.
14. Turn the Drain Valve, at the bottom of the
Tank, two turns to release any built-up
moisture and the internal tank pressure.
Close the valve after moisture has drained
out. Do not remove the Drain Valve.
15. Clean, then store the Air Compressor indoors.
2. Possible causes of repeated automatic
shut off of the compressor are:
a. Using an extension cord that
is too long or narrow;
b. An air leak or open hose causing the compressor
to cycle too often and build up heat.
3. Correct any issues before further use to
avoid damage to the compressor.
Page 11