Connecting Power Supply; Turning On The Power - Hitachi ED-X45N User Manual

Connecting power supply

1. Put the connector of the power cord into the
AC IN (AC inlet) of the projector.
2.
outlet. In a couple of seconds after the
power supply connection, the POWER indicator
will light up in steady orange.
function activated, the connection of the power supply
make the projector turn on.
WARNING
your dealer to get a new one.
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.

Turning on the power

1.
and correctly connected to the projector
and the outlet.
2. Make sure that the POWER indicator is
steady orange. Then remove the lens
cover.
3. Press the STANDBY/ON button on the
projector or the remote control.
The projection lamp will light up and the
POWER indicator will begin blinking in
green. When the power is completely on, the
indicator will stop blinking and light in steady
green.
WARNING
not look into the lens of the projector or look inside of the projector through any
of the projector's openings.
NOTE
17, 19)
Guide". (
Please use extra caution when connecting the power cord, as
AC IN Power cord
STANDBY/ON button
POWER indicator
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU
ENTER
ESC RESET
9