Advertisement
NIGHT DIMMING
Your display system has a dimming feature that dims the display intensity automatically at night. Normally the system is at full
brightness for daytime viewing. To have the system at full brightness all of the time, go into the setup menu as described above and
select "" (night). Press and release the function switch to select "" instead of "". Press and hold the function switch to save
the new setting.
Press and release the switch until "" is displayed, then press and hold the switch until " – " is displayed.
Release the switch. The current setting will be displayed. (, ).
Press and release the switch until the desired setting is displayed.
Press and hold the switch until " " is displayed to save the setting.
Miles to Next Service setup
The service mileage is a countdown mile meter. The service mile display can be disabled or can be set to count down from
500 – 7500 miles. If the service mileage is enabled and it gets to 0 miles it will display "" each time the key is turned on. If the
push button switch is pressed and held while "" or "" and a mileage is displayed, the service miles will be reset to your preset
value.
Press and release the switch until "" is displayed, then press and hold the switch until " – " is displayed.
Release the switch. The current setting will be displayed, "" or a mileage from – .
Press and release the switch until the desired setting is displayed.
Press and hold the switch until " " is displayed.
Performance menu setup
The performance readings can be turned on or off. When they are turned off the odometer will only toggle through the
mileage readings.
Press and release the switch until "" is displayed, then press and hold the switch until " " is displayed.
Release the switch. The current setting will be displayed ( or ).
Press and release the switch until the desired setting is displayed.
Press and hold the switch until " " is displayed.
Odometer preset
The odometer can be preset by the customer within the first 100 miles. Once the odometer has more than 100 miles the menu option
will no longer be displayed. Make sure you have correctly selected the units to be either MPH or km/h first. The odometer will be set
in the selected units. Once you have preset the miles you cannot change it again.
WARNING!!: This only allows setting odometer to the nearest mile. Do not use tenths! For example a mileage of 65432.1
should be set to "" using this method. If the tenths digit is used, the odometer will read 10 times too high.
Press and release the switch until "" is displayed, then press and hold the switch until " " is displayed.
The current miles will be displayed with the left most digit flashing.
Press and release the switch to increment the digit. Press and hold the switch to move to the next digit to the right.
Continue until the right most digit has been set. Press and hold the switch and the speed display will show "".
Press and hold the switch while "" is displayed to go back and continue changing the odometer display. Turn the key off to
cancel any changes.
Press and release the switch to change to speed display to "". Press and hold the switch while "" is displayed to save the
current odometer reading.
MAN# 650272:C
Advertisement
