Table of Contents
Advertisement
6.1 Sending a fax manually
MFaxN
MRedialN
MSP-PhoneN
Mc/dN
1
If the MFaxN light is OFF, turn it ON by pressing
MFaxN repeatedly.
2
Set the original (page 18).
3
If necessary, change the resolution and contrast
according to the type of document.
R To select the contrast, see page 35.
R To select the resolution, see page 35.
4
Dial the fax number.
5
Press MStartN to scan the document into memory.
Wait until "SCAN:PRESS SET" "SEND:PRESS
START" is displayed.
6
To send a single page:
Press MStartN.
To send multiple pages:
1. Place the next page on the scanner glass. A
MSetN
R To send more pages, repeat this step.
2. When all pages are scanned, press MStartN.
Note:
R To stop sending, see page 58.
R While talking to the other party using the
MSP-PhoneN, you can send a fax using the scanner
glass by pressing MStartN, and then M1N (To receive
a fax, press M2N).
R You can change the default operation mode (feature
#463 on page 49) and the timer before returning to
the default operation mode (feature #464 on
page 49).
MStartN
MSetNMCNMDN
6. Fax (KX-MB1520 only)
To select the contrast
Adjust this setting depending on the darkness or
lightness of the document. 5 levels (low to high) are
available.
1. Press Mc/dN repeatedly to display "CONTRAST".
2. Press MCN or MDN to change the contrast.
3. MSetN
To select the resolution
1. Press Mc/dN repeatedly to display "RESOLUTION".
2. Press MCN or MDN to change the resolution.
– "STANDARD": For normal-sized characters.
– "FINE": For small-sized characters.
– "SUPER FINE": For very small-sized characters.
– "PHOTO": For photographs, shaded drawings,
etc.
3. MSetN
R Using the "FINE", "SUPER FINE" and "PHOTO"
settings will increase transmission time.
To redial the last number
MRedialN
R If the line is busy, the unit will automatically redial the
number 1 time.
Note:
R To stop sending, see page 58.
Reserving the fax transmission (Dual Access)
You can reserve a fax transmission even when the unit
is just receiving a fax or sending a fax from memory.
– Up to 3 reservations when sending
– Up to 4 reservations when receiving
1. Set the original during fax reception or fax memory
transmission.
2. Enter the fax number using the dial keypad or
phonebook.
3. MStartN
R The unit will scan 1 page. Place the next
document on the scanner glass and press MSetN.
Repeat this until all the documents are scanned,
then press MStartN.
R If the document exceeds the memory capacity, the
reservation for that document will be cancelled. You
must send the entire document manually.
Printing a confirmation report
A confirmation report provides you with a printed record
of transmission results. To print the confirmation reports,
make sure that feature #401 is activated (page 50). For
an explanation of the messages, see page 59.
Printing a journal report
A journal report provides you with a printed record of the
30 most recent faxes. To print it manually, see
page 72. To print it automatically after every 30 new
fax transmissions and receptions, make sure feature
35
Advertisement
Table of Contents
