Table of Contents
Advertisement
1. Introduction and Installation
R The unit is set for printing letter-size plain paper
by default.
– To use other paper sizes, change the
recording paper size setting (feature #380 on
page 48).
– To use thin paper, change the recording paper
type setting (feature #383 on page 49).
1
Lift the paper input tray (A), and pull it completely
out.
A
2
Before loading a stack of paper, fan the paper to
prevent paper jams.
14
3
Load the paper, print-side down (A).
Important:
R Push down to lock the plate (B) in the paper
input tray, if necessary.
A
4
Adjust the recording paper guides. Pinch the rear
guide (A), then slide it to match the paper size mark.
Pinch the right guide (B), then slide it to adjust the
width to the size of the recording paper.
R Make sure that the recording paper is under the
paper limit mark (C), and the paper should not
be loaded over the snubbers (D).
C
B
D
A
B
Advertisement
Table of Contents
