Step 2: Installing The Handlebar Base - Garmin ZUMO 665 Quick Start Manual

zumo 665 Installation Instructions
&WARNING
Incorrectly wiring the power cable with bare wir leads can re ult in damage to the vehicle or
the battery and can cause bodily injury. Garmin strongly recommends having an experienced
in taller with the proper knowledge of electrical systems install the unit.
See the Important Safety and Product Information guide in the product box for product
warning and other important information.
Do not u e the uction cup mount on a motorcycle.
Step 1: Connecting Power to the Mount
Select a uitable and secure location to mount the zumo on your motorcycle, based on
a ailable power sources and safe cable routing.
Cradle
Microphone jack (2.5 mm)
Headphone/audio out jack (3.5 mm)
Bare wires with
inline fuse for
power connection
-....;:::
-
Mini-USB connector
(for GXM 40 Antenna)
Step 2: Installing the Handlebar Base
NOTICE
The recommended torque i 50 Ibf-in. Do not exceed torque of 80 Ibf-in.
The zumo includes parts for two handlebar installation solution. Custom mounts can require
additional hardware (www.ram-mount.com).
Option A: Installing the U-bolt and Handlebar Base:
1. Place the U-bolt around the handlebar, and thread the ends through the handlebar base.
2. Tighten the nuts to secure the base. Do not overtighten.
Handlebar
U-bolt