Table of Contents
Advertisement
2. SPECIFICA
2. SPECIFICA
TIONS
TIONS
2. SPECIFICA
2. SPECIFICATIONS
2. SPECIFICA
TIONS
TIONS
Rated Power Consumption ... 1650W.
Microwave Output ................. 1100W.
Frequency .............................. 2,450MHz±50MHz.
Power Supply ......................... 120V±12V, 60Hz.
Rated Current ........................ 14.0 Amp.
Safety Devices ...................... Thermal Fuse open at 332° F
Timer ...................................... Electronic Digital, up to
Overall Dimensions ............... 29
Oven Cavity Size ................... 19
Turn Table Diameter ............... 10
Effective Capacity of
Oven Cavity ........................... 1.5 Cubic Feet.
Net Weight ............................ Approx. 59.5 Lbs.
3. POWER OUTPUT MEASUREMENT
3. POWER OUTPUT MEASUREMENT
3. POWER OUTPUT MEASUREMENT
3. POWER OUTPUT MEASUREMENT
3. POWER OUTPUT MEASUREMENT
NOTE
NOTE
NOTE
NOTE
NOTE
The power output specification, 1000 W. on this model is
measured with IEC measurement. The power output is
measured with two ( 2 ) liters water is equivalent to 1000 W.
in measurement with IEC, when measured with the following
power output.
(1) Fill two beakers ( glass or plastic ) with each one liter
of tap water ( about 20
perature. ( Use a thermometer with a 1/10 degree gauge ).
(2) Place the beakers side by side in the center of the glass
tray.
(3) Close the door, set the "TIME" for two minutes. ( "200"
in the display window. ) Touch the "START" key and
heat the water exactly for two minutes.
(4) Take the beakers out, immediately stir the water and
measure the water temperature respectively.
(5) Calculate the temperature rise of water in each beaker.
Then calculate the average value of two temperature rises.
Output power can be calculated by the equation :
Power Output (W) = 70 x ∆t
Where ∆t is an average temperature rise in degrees
Centigrade.
(6) Power output shall be in the following range :
Average Temperature Rise
Minimum
23.0
Maximum
28.3
(7) Power Output is affected by the line voltage under load.
For correct Power Output measurement, the line voltage
under load must be 120±1volts.
(167
o
C) for Cavity & Bottom.
Thermal Protector open at
o
252° F(122
C) for Magnetron.
Thermostat close at 140° F
(60° C) for Hood Fan.
Fuse (Cartridge Type 20A)
Primary Interlock Switch,
Door Sensing Switch and
Relay 2.
Interlock Monitor Switch.
99min. 99 sec.
7
/
"(W) x 14
1
/
"(D) x 17"(H)
8
8
1
/
"(W) x 13
1
/
"(D) x 9
4
2
13
/
"
16
o
C ) and measure the water tem-
Power Output
o
o
F(12.8
C)
o
F(15.7
o
C)
1099W
4 . 4 . 4 . 4 . 4 . PRECAUTIONS AND REP
PRECAUTIONS AND REP
PRECAUTIONS AND REP
PRECAUTIONS AND REP
PRECAUTIONS AND REPAIR SER
PRELIMINAR
PRELIMINAR
PRELIMINARY Y Y Y Y
PRELIMINAR
PRELIMINAR
A. A.
A. A. SINCE NEARL
A.
SINCE NEARLY 2,000 VOL
SINCE NEARL
SINCE NEARL
SINCE NEARL
CUITS OF THIS MICROWA A A A A VE OVEN, REP
CUITS OF THIS MICROW
CUITS OF THIS MICROW
CUITS OF THIS MICROW
CUITS OF THIS MICROW
BE CARRIED OUT WITH GREAT CARE.
BE CARRIED OUT WITH GREA
BE CARRIED OUT WITH GREA
BE CARRIED OUT WITH GREA
BE CARRIED OUT WITH GREA
B. B. B. B. B. TO A
TO A
TO A
TO A
TO AVOID POSSIBLE EXPOSURE TO MICROW
VOID POSSIBLE EXPOSURE TO MICROW
VOID POSSIBLE EXPOSURE TO MICROW
VOID POSSIBLE EXPOSURE TO MICROW
VOID POSSIBLE EXPOSURE TO MICROWA A A A A VE
ENERGY LEAKAGE, THE FOLLOWING PRECAUTIONS
ENERGY LEAKAGE, THE FOLLOWING PRECAUTIONS
ENERGY LEAKAGE, THE FOLLOWING PRECAUTIONS
ENERGY LEAKAGE, THE FOLLOWING PRECAUTIONS
ENERGY LEAKAGE, THE FOLLOWING PRECAUTIONS
MUST BE T
MUST BE TAKEN BEFORE SER
MUST BE T
MUST BE T
MUST BE T
(1) Before the power is applied :
(a) Open and close door several times to make sure the
primary interlock switch, the interlock monitor switch
and the door sensing switch operate properly.
(Listen for the clicking sound from the switches.)
Make sure the interlock monitor switch closes after
the primary interlock switch is opens when the door
is opened.(See pages 1 and 6)
(b) Make sure the perforated screen and the choke die-
lectric of the door are correctly mounted.
(2) After the power is applied :
7
/
"(H)
8
(a) Open and close the door to see if the interlock mech-
anism operates properly.
(b) Check microwave energy leakage with a leakage
detector and confirm the energy leakage should be
no greater than 4mW/cm
uncertainty.
(3) Do not operate the unit until it is completely repaired,
if any of the following conditions exists :
(a) Door does not close firmly against the cavity front.
(b) The hinge is broken.
(c) The choke dielectric or the door seal is damaged.
(d) The door is bent or warped, or there is any other
visible damage to the oven that may cause microwave
energy leakage.
Always keep the seal clean.
Always keep the seal clean.
NOTE :
NOTE :
Always keep the seal clean.
Always keep the seal clean.
Always keep the seal clean.
NOTE :
NOTE :
NOTE :
(e) Make sure that there are no defective parts in the
interlock mechanism.
(f) Make sure there are no defective parts in the
microwave generating and transmission assembly.
(especially waveguide).
(4) The following items should be checked after the unit
is repaired :
(a) The interlock monitor switch is connected correctly
and firmly.
(b) The magnetron gasket on the magnetron is properly
positioned.
(c) Waveguide and oven cavity are intact (no leakage of
microwave energy).
(d) The door can be properly closed and the safety
switches work properly.
(e) The oven must be stopped when the door is opened
896W
or the time is up.
The oven must not be operated with any of the
The oven must not be operated with any of the
The oven must not be operated with any of the
The oven must not be operated with any of the
The oven must not be operated with any of the
above components r
above components r
above components removed or bypassed.
above components r
above components r
- 2 -
AIR SER
AIR SER
AIR SER
AIR SERVICE TIPS
Y 2,000 VOLTS EXISTS IN SOME CIR-
Y 2,000 VOL
Y 2,000 VOL
Y 2,000 VOL
TS EXISTS IN SOME CIR-
TS EXISTS IN SOME CIR-
TS EXISTS IN SOME CIR-
TS EXISTS IN SOME CIR-
VE OVEN, REP
VE OVEN, REP
VE OVEN, REP
VE OVEN, REPAIRS SHOULD
T CARE.
T CARE.
T CARE.
T CARE.
AKEN BEFORE SER
AKEN BEFORE SER
AKEN BEFORE SERVICING.
VICING.
VICING.
VICING.
AKEN BEFORE SER
VICING.
2
to allow for measurement
emoved or bypassed.
emoved or bypassed.
emoved or bypassed.
emoved or bypassed.
VICE TIPS
VICE TIPS
VICE TIPS
VICE TIPS
AIRS SHOULD
AIRS SHOULD
AIRS SHOULD
AIRS SHOULD
VE
VE
VE
VE
Advertisement
Table of Contents
